HETRONIC NOVA XL - Technical Specification Transmitter Nova XL

USER MANUAL | NOVA XL
2
Transmitter Specifications
Transmitter NOVA XL
Housing
Ergonomically designed Impact Resistant Polymer Composite
Environmental Protection
IP 65 (Exceeds Nema 12/13)
Weight
~1.9kg (4.1lbs) depending on configuration
Dimensions
Height: 165 mm
Width: 312 mm
Depth: 170 mm
Antenna
Internal as default, external via TNC connector
Power Supply
3.6V NiMH rechargeable battery pack or
5V to 30V via cable control
Diagnostics
Status LED for operation and standard/advanced low battery
detection
Battery Operation Time
Min 12 hrs continuous transmission* for NiMH
Min 20 hrs continuous transmission* for Li-Ion
Control Configuration
4x Single/Dual/Triple axis cross joysticks
8x Single axis paddle levers
Any combination of key switches, toggle switches, push buttons,
rotary switches, potentiometers and stop switches
Customized switches available upon request
Half or Full duplex feedback
Frequency Range
4xxMHz or 8xxMhz or 9xxMHz or 1.216GHz or 2.4GHz**
Power (RF Output)
Typically ≤ 10mW E.I.R.P
Typical Operating Range
150m (492ft) for ≤ 1GHz 10mW module (Line-of-Sight)
70m (150ft) for 2.4GHz 10mW module
Safety
20-bit programmable address concept with up to 1,000,000
combinations
Operating Temperature Range
Active & Passive Stop Function
Parity and Checksum
-25°C . . . 70°C (-13°F . . . 158°F)
Humidity Range
0 - 97% maximum non-condensing
Response Time
Less than 100 msec.
Accessories and options
Belly belt, neck belt or shoulder bar
Cushion and customer logo option
Optional Custom housing colour
RS232/CAN Cable control
LCD Display
LCD
Monochrome LCD 120x320
Technical Specification Transmitter Nova XL
*varies by transmitter configuration and battery type
** for full Channel Lists refer to Frequency Bands Radio Modules Charts
*** higher power available subject to country legislation
Monochrome LCD Display (optional)
There are several standard screens that are displayed on the LCD:
1. Software version
As soon as the display turns on the LCD type and software version installed in the controller are displayed.
2. Welcome screen
The standard Hetronic welcome screen is displayed as soon as the LCD display turns ON after Start Up. The user can opt to choose a
different welcome screen by defining the requirements with an authorized Hetronic dealer who can then implement this via a specific
graphics programming tool or else choose from the available options when placing the order.
GRAPHIC LCD 120x32
SOFT. VERSION: 2.60