USER MANUAL | NOVA XL
3
3. Feedback
The feedback function is used to transmit information from the machine or receiver to the transmitter in half or full duplex operation. A
number of graphic modes (with different positions and sizes of graphic icons) or up to four lines of text may be used to display the
feedback information on the LCD, the format being dependent on the type of message received from the machine. Up to four other on/off
digital outputs can also be designated through LCD Feedback.
Contact a Hetronic dealer for information on how to display feedback accordingly.
4. Feedback Error
If the antenna symbol flashes, this means that there is feedback failure i.e. the transmitter has not received a valid telegram for 5 seconds.
When this happens there is an imminent risk of losing radio connection thus it is important to check that there are no obstacles blocking the
connection and that the units are within the range of the radio system.
5. STOP
The STOP screen is displayed whenever the Transmitter is in STOP mode. This can be achieved when in Active (User manually activates
the Stop button #6) or Passive Stop (Transmitter is outside the Antenna reception range or an error occurs).
Battery & Charger
You may power your Nova XL transmitter with a Hetronic rechargeable NiMH 3.6V Grey MINI battery inserted in the battery compartment
in the bottom side of the transmitter.
Follow the instructions below to ensure best performance of your transmitter and prolonged battery lifetime.
1. Confirm that your batteries are fully-charged. See “Recharging Your Batteries” section in the UCH 2 Charger section.
2. Slide the recharged battery into the battery compartment at the bottom of the transmitter as shown, and snap it into place.
Cable Back-up
Cable control on Nova-XL transmitters is possible through either the battery compartment or from a connector plug installed on the side of
the transmitter. For back up/control via the battery compartment, the battery will have to be removed. For back up/control via the connector
plug, the battery may be left inside the battery compartment as the coder will automatically detect the presence of the cable and disable all
wireless activity.
Note: When the transmitter is in cable control, the coder offers the possibility to recharge the battery if this is left inside the battery
compartment in the transmitter.
Refer to Section 6.9 for more details.
Accessories and Spare Parts
The standard belts for the NOVA XL transmitter are the neck and belly belt and these can be obtained with or without the cushion and with
or without the logo.
Refer to the online web shop for respective part numbers of any other parts that may need replacement:
https://shop.hetronic.com.mt/en/home
NOTE: Any service/maintenance work and replacement of parts must be carried out by an authorized dealer or service centre specified by
Hetronic.
To Next Page
Loading...
