USER MANUAL | UCH 3 CHARGER
1
UCH 3 Battery Charger
Follow the instructions below to ensure best performance of your transmitter and prolonged battery lifetime.
Recharging your Batteries
To charge the 3.7V Li-Ion Battery pack, it must be removed from the transmitter by lifting it up and sliding it out of the battery compartment.
Slide the battery pack in the charging unit until it clips in place and make sure that at least one of the four red LEDs switches on. The red
LEDs will switch ON sequentially as charging progresses and during the whole charging process. When the battery is fully charged, the red
LEDs switch off and the three green LEDs switch on instead.
Leave the battery in the charger until it is needed. The charger supplies a “trickle” charge but it will not over-charge the battery.
The charger power cable is supplied with different plugging options: EU plug, cigarette lighter plug, US plug, etc.
Charger plug variations
EXPLOSIVE GASES AND FLYING DEBRIS can cause death or serious injury. Use only Hetronic replacement rechargeable
batteries. Use of unauthorized replacement batteries could cause a battery explosion resulting in injury or death of the operator
or other people in the work area.