14/31
6 Settings and enquiries
6.1 Setting the machine version
The machine version stored in the control panel must correspond to the centrifuge
model. Control panels supplied as spare part are set to machine version 4 (ROTOFIX
32).
After installing the control panel the EBA 20 must be set to machine version 1 and the
EBA 20 C to machine version 5.
If another machine version than 1 or 5 is set in the control panel, the set machine
version will appear in the display after switching on the centrifuge.
Now the correct machine version has to be set as follows:
1. Set the correct machine version for
EBA 20 or EBA 20 C by using the
and keys beneath the time
indicator.
RPM x 100
t
START
STOP
2. Press the key
STOP
in order to store the set machine version.
To Next Page
Loading...
