15/31
6.2 Enquiry the machine version
The enquiry of the machine version is only possible if the rotor is at standstill.
1. Switch off the mains switch.
2. Keep the key beneath the speed display and the key pressed simultaneously.
3. Switch on the mains switch and release the keys again.
The speed indicator shows the machine version and the time indicator shows the set
brake step: e.g.:
EBA 20:
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
EBA 20 C:
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
If the machine version and brake step are not displayed, press the key under the
speed indicator until they are displayed.
4. To exit the machine version display press the key
STOP
or perform a MAINS-
RESET.
To Next Page
Loading...
