16/31
6.3 Enquiry the programme versions
The enquiry of the programme versions is only possible if the rotor is at
standstill.
1. Switch off the mains switch.
2. Keep the key beneath the speed display and the key pressed simultaneously.
3. Switch on the mains switch and release the keys again.
The speed indicator shows the machine version and the time indicator shows the set
brake step.
EBA 20:
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
EBA 20 C:
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
4. Press the key beneath the speed indicator so often until the programme version of
the control panel (e.g. b1.12) is displayed.
RPM x 100
t
START
STOP
5. Press the key
beneath the speed indicator again.
The programme version of the power board (e.g. C1.03) is displayed.
RPM x 100
t
START
STOP
6. To exit the programme versions display press the key
STOP
or perform a MAINS-
RESET
To Next Page
Loading...
