18/31
6.5 Locking the input of the speed, time and brake step and locking the key
(only with EBA 20 C)
Locking of the key and locking of the input of the speed, time and brake step
is only possible with machines with machine version 5 (EBA 20 C) and a
programme version of the control panel from b1.40.
The activation and deactivation of the lock is only possible if the rotor is at
standstill.
1. Switch off the mains switch.
2. Keep the key
beneath the speed display and the key pressed simultaneously.
3. Switch on the mains switch and release the keys again.
The speed indicator shows the machine version and the time indicator shows the set
brake step:
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
If the machine version and brake step are not displayed, press the key under the
speed indicator until they are displayed.
4. Keep the key
START
pressed and then press the key beneath the speed indicator.
In the speed indicator the letter "c" is displayed, this means that the input of the
speed, time and brake step is now locked and the keys and are deactivated.
RPM x 100 t
START
STOP
RPM x 100 t
START
STOP
To deactivate the lock also keep the key
START
pressed and then press the key
beneath the speed display.
5. Press the key
STOP
to save the setting.
6.6 Lid lock control
The lid can be opened when the rotor is at standstill and the key is pressed. The
solenoid on the lid lock remains energized for three seconds.
To Next Page
Loading...
