Chapter
4
4 Safety
The following chapter provides safety and regulatory information for the 4U60 Storage Enclosure.
4.1 Optimizing Location
Failure to recognize the importance of optimally locating your product and failure to protect against electrostatic discharge
(ESD) when handling your product can result in lowered system performance or system failure.
Do not position the unit in an environment that has extreme high temperatures or extreme low temperatures. Be aware of
the proximity of the unit to heaters, radiators, and air conditioners.
Position the unit so that there is adequate space around it for proper cooling and ventilation. Consult the product
documentation for spacing information.
Keep the unit away from direct strong magnetic elds, excessive dust, and electronic/electrical equipment that generate
electrical noise.
4.2 Safety Warnings and Cautions
To avoid personal injury or property damage, before you begin installing the product, read, observe, and adhere to all of
the following safety instructions and information. The following safety symbols may be used throughout the documentation
and may be marked on the product and/or the product packaging.
CAUTION Indicates the presence of a hazard that may cause minor personal injury or property damage if the CAUTION
is ignored.
WARNING Indicates the presence of a hazard that may result in serious personal injury if the WARNING is ignored.
Indicates potential hazard if indicated information is ignored.
Indicates shock hazards that result in serious injury or death if safety instructions are not followed.
Indicates do not touch fan blades, may result in injury.
Indicates disconnect all power sources before servicing.
4.3 Electrostatic Discharge
CAUTION
Electrostatic discharge can harm delicate components inside HGST products.
Electrostatic discharge (ESD) is a discharge of stored static electricity that can damage equipment and impair electrical
circuitry. It occurs when electronic components are improperly handled and can result in complete or intermittent failures.
Wear an ESD wrist strap for installation, service and maintenance to prevent damage to components in the product. Ensure
the antistatic wrist strap is attached to a chassis ground (any unpainted metal surface). If possible, keep one hand on the
frame when you install or remove an ESD-sensitive part.
11
Installation Guide 4 Safety
To Next Page
Loading...
Need help?
General