HID ENTRYPROX - 7.3 Programming PIN Code Only Use; 7.4 Programming CARD Only Use; 7.5 Programming Code or Card

Page 26 of 38 September 2016
EntryProx User Manual, 4045-905, Rev. C.4
7.3 Programming PIN Code Only Use
To program PIN Code operation with Command 50, use the following program sequence:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 50 # user-type # user location # keypad PIN
* keypad PIN *
3. Press * to exit program mode.
7.4 Programming CARD Only Use
To program Card only use with Command 50, simply omit the keypad PIN values from the
sequence:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 50 # user-type # user location # **
<present card>
3. Press * to exit program mode.
7.5 Programming Code or Card
To program a user for either Code OR Card:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 52 # user-type # user location # keypad PIN
* keypad PIN * <present card>
3. Press * to exit program mode.