Page 30 of 38 September 2016
EntryProx User Manual, 4045-905, Rev. C.4
8.3 Resetting the Master Cod and System Defaults Only
Command 40 erases everything from the EntryProx memory except the user list and transaction log
and restores the default settings. This is useful if the EntryProx unit has experienced programming
problems, or if you wish to delete earlier programming.
When you do this command the following rules apply:
If user #0 has not been programmed and user #1 is programmed then user #0 is erased and
user #1 is set to default (1234).
If user #0 has been programmed and user #1 has not been modified, user #0 and user #1 are
set to default data (1234).
If user #0 has been programmed and user #1 has been modified, user #0 is set to default
(1234) and user #1 is not changed.
Note: You must change the master code after performing this command.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. Press: 40 # 00000 # 00000 # **
3. Press * to exit program mode
8.4 Erasing Entire Memory/Resetting System Defaults
Command 46 deletes everything from the EntryProx memory including the user list but not the
transaction log and restores the default settings. This is used as a last resort if you need to erase a
specific user and could not retrieve the Programmed User List. After performing this command the
master code must be reprogrammed.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. Press: 46 # 00000 # 00000 # **
3. Press * to exit program mode.
8.5 Turning KeyPress Audible Feedback On/Off
The Keypress Audible Feedback command enables the sounder to beep once for each key press.
This feature provides an audible acknowledgment that a particular key was pressed hard enough for
the unit to understand. The factory-shipped default setting is ON, but it can be toggled ON and
OFF as desired using command 30.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. To enable this feature
Press: 30 # 0 # 1 # **
3. To disable this feature
Press: 30 # 0 # 0 # **
4. Press * to exit program mode
To Next Page
Loading...