September 2016 Page 31 of 38
EntryProx User Manual, 4045-905, Rev. C.4
8.6 Turning Keypress Visual Feedback On/Off
The keypress visual feedback feature lights the LED once for each key press. This feature provides a
visual acknowledgment that a particular key was pressed hard enough for the unit to understand.
The factory-shipped default setting is ON, but it can be toggled ON and OFF as desired.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. To enable this feature
Press: 30 # 1 # 1 # **
3. To disable this feature
Press: 30 # 1 # 0 # **
4. Press * to exit program mode
8.7 Auto Entry Enable
This function is not recommended for use, as it lowers the overall security of the unit and affects
programming sequences ending with the * key. It is set with the 30# command (Set/Clear Standard
Options). When this feature is enabled, any PIN code the same length as the master code does not
require the * key. Leave this feature in the default mode, which is OFF.
To Next Page
Loading...