© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC4500e Card Printer User Guide, PLT-01669, 1.0
3.1 Driver Installation Instructions
Start the installation process by inserting the Driver CD into the computer; then, follow the
Installaware Wizard screen prompts.
• Select “Install the Printer Driver” to start the driver installation.
• Select the FARGO Workbench Utility Program to install the Diagnostic program.
• Select Swift ID™ to install the Swift ID (Embedded Badging Application software) and
follow the Installaware Wizard on-screen prompts.
o All versions of Windows require Administrator rights.
• From the Printer & Faxes, select Printing Preferences to setup the printer driver after it
has been installed.
• Use the drop down arrows to select the correct options for each printing preference.
• Check Enable Swift ID over a USB connection: to use Swift ID via a USB connection.
o When this box is checked, the Ethernet connection (if applicable) to the printer will
not be operational.
o If this selection is not accessible, this is because the HID EEM Driver that Swift ID
uses to connect via a USB connection has not been installed.
o This driver can be found on the installation CD or it can be downloaded from the HID
Global support page.
o The easiest method for enabling Swift ID is to un-install the printer and its
components and reinstall the printer with Swift ID selected.
3.2 Swift ID Installation Instructions
Here are the related definitions for the Swift ID installation instructions.
• Swift ID: This is a ‘built-in badging’ application that enables Users to create simple ID
badges without having to install any additional software.
Note: This application is only intended for use between one printer and one PC. The
application cannot select between printers, and only one printer per PC can access Swift
ID.
• HID EEM Driver: This Driver is used by Swift ID to communicate with the PC when
connected via a USB cable.
Note: EEM is the acronym for ‘ETHERNET Emulation Module’.
To Next Page
Loading...
