© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC4500e Card Printer User Guide, PLT-01669, 1.0
3.2.4 Printer Connected Via USB Connection
Perform this procedure on the initial setup of a printer when connecting Swift ID via USB.
Note: This application is not intended for use with multiple printers.
To start using Swift ID via a USB connection with a printer that has already been installed on
the PC, select Option 1 or 2 and complete the procedure.
1 Follow the on-screen instructions during the Printer Driver installation process to install all
the required components to access Swift ID via a USB connection.
Note: The HID EEM Driver installs. A shortcut appears on the desktop, which allows you
to easily launch the application.
3.2.4.1 Option 1
Step Procedure
1
Uninstall the printer driver, reinstall the printer driver and check the Enable Swift ID over
a USB connection check box.
3.2.4.2 Option 2
1 Install the HID EEM Driver from the driver CD or download the HID EEM Driver installer
file from the support page
2
Run the installation file.
3
When the installation is complete, check the Enable Swift ID over a USB Connection
check box in the Advanced section of the printer driver.
Note: When this flag is checked, a new printer instance appears and the old printer
instance is no longer valid.
3.2.5 Uninstalling Swift ID
For a printer installed on a network, no steps are needed to remove any of the components of
Swift ID.
For a printer that is connected via a USB connection, deselect (uncheck) the Enable Swift ID
over a USB Connection check box in the advanced section of the printer driver and then run
the uninstall HID EEM Driver setup.
Note: When this flag is disabled, a new printer instance appears and the old printer instance
is no longer valid.
To Next Page
Loading...
