© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC4500e Card Printer User Guide, PLT-01669, 1.0
Setting Option
Erase Heat Offset
Adjust the Erase temperature for the rewriteable cards as needed.
• Increase the Current Setting to cause more heat to be used
in the erasing process.
OR
• Decrease the Current Setting to cause less heat to be used
in the erasing process.
Note: Erase Heat Offset provides user ability to control the
Printhead heat level when the Erase Operation is performed.
Appropriate heat levels should be applied for the proper erase
process. This setting should be adjusted for proper erasure.
Write Heat Offset
Adjust the Write temperature for the rewriteable cards as needed.
• Increase the Current Setting to cause more heat to be used
in the printing process of a rewritable card.
OR
• Decrease the Current Setting to cause less heat to be used
in the printing process of a rewritable card.
Note: Write Heat Offset provides user ability to control the
Printhead heat level when the Write Operation is performed.
Appropriate heat levels should be applied for the proper writing
Enable Swift ID over USB
connection
Check this item to utilize Swift ID via a USB connection. When this
box is checked the Ethernet connection (if applicable) on the
printer will not be operational.
• If the USB selection is not be accessible, the HID EEM driver
that Swift ID uses to connect via a USB connection has not
been installed.
• This driver can be found on the installation CD or it can be
down loaded from the HID Global support page.
• The easiest method for enabling Swift ID is to uninstall the
printer driver and its components and go through the
installation procedure.
Select the desired connection type for the Swift ID application:
To Next Page
Loading...
