What does '# 106 Job Data Error' mean on my HID Printer?
The print data sent to the printer is corrupt or has been interrupted. Check the interface cable. Select the ON/OFF button to cancel this print job and then resend the job.
What does '# 45 No Flip Module installed' mean on my HID Printer?
Request to print on 2nd side of card, but no flipper is installed. If a Flipper Module is present, ensure that the Print Both Sides option in the printer driver is set correctly. Install a flipper module.
What does '# 44 Flipper Jam/ Home Error' mean on my HID Printer?
A card has become jammed in the printer’s flipper table. The flipper failed to position properly while aligning a card or flipping a card. Clear any cards in the flipper table using the buttons to move the card out. Resume printing. The flipper table should be level when the printer is powered up. If the flipper Table is at an angle, open the card output door and manually level it. Then cycle the printer power to reset. Reset the printer and retry. If problem persists call for technical assistance.
What does '# 31 No Mag Module' mean on HID Printer and how to fix it?
The printer is not configured with the encoder data type that you are trying to send. Ensure that no encoding data is being sent with the print job and reprint the card. Install a magnetic encoding module.
What to do if my HID Printer displays '# 68 Card in Printer'?
A card is jammed in the print station or card flipping area of the printer. Clear the jam, then press the Pause button to continue printing.
What does '# 136 Secure Guard Print Disabled' mean on my HID Printer?
Printing is disabled by SecureGuard until a password is received. Reset the printer and retry. If the problem persists, call for technical assistance.
What does '#202 Encoder not installed' mean on HID Printer?
You are trying to send encoding data, but the Printer is not configured with this Encoder type (iCLASS, Prox, MIFARE, SmartCard). Ensure that no encoding data is being sent with the print job and reprint the card. Install an encoding module.
What causes '# 109 # 113 Ribbon Release Error' on my HID Printer?
The printer cannot locate the next ribbon panel in order to release the ribbon from the card. Ensure that the ribbon is not stuck to the card. Replace the ribbon. Recalibrate the ribbon sensor. If the ribbon is broken, repair by taping the ribbon back onto the take- up core and manually advance to the next panel. Press the Pause button to continue.
How to troubleshoot '# 30 Mag Verify Error' on HID Printer?
Magnetic encoding verification has failed. Try encoding with a different card. Verify cards have the magnetic stripe. Replace the magnetic encoding module.
What to do if my HID Printer says '# 25 Ribbon not Installed'?
No ribbon is installed in the printer. Install a ribbon and retry.
To Next Page
General