42 - 48
7.4.1 INSTALLER’S PARAMETERS MODIFICATION
Installer’s parameters allow the advanced setting of the unit.
Some parameters regard important modifications to the unit.
MODIFY ONLY IF NECESSARY
To enter the installer menu, follow this process:
- Go to the main screen pressing EXIT if necessary
- Press MENU to enter the first screen of the user menu
- Press DOWN up to the last screen (screen 9)
- Press OK
- The password is required, insert “ 0010 “ and confirm by pressing OK
This menu is composed by 10 screen:
1. Fan speed
2. Filter cleaning timer
3. Dehumidification differential
4. Heating differential *
5. On/off contact at distance *
6. On/off contact dehumidification *
7. On/off contact heating *
8. Serial modbus *
9. Alarm history
10. Recover default values
* screen not always present
USE OF THE KEYS DURING THE SURFING WITHIN THE SCREENS:
- With UP and DOWN you pass from a screen to another (some screens are displayed only in some cases)
- With EXIT you exit and come back to the main screen
- With OK you enter in the modification mode
USE OF THE KEYS DURING THE MODIFICATION:
- With UP and DOWN you modify the highlighted value
- With EXIT you exit from the modification
- With OK you confirm the highlighted value and, if there are some following values to modify, you pass to the next one,
otherwise you exit from the modification
To Next Page
Loading...
