Hikmicro HABROK Series User Manual

Multi-spectrum Binocular User Manual
10
Note

Power-off countdown will appear when you power off the device. You
can press any key to interrupt the countdown and cancel the power-off.

Automatic low battery power-off cannot be canceled.
Auto Power Off
You can set the auto power off time for your device.
Steps
1. Press to show the menu.
2. Go to Advanced Settings, and select General Settings.
3. Press or to select , and press to enter the
configuration interface.
4. Press or to select the auto power off time as required, and
press to confirm.
5. Hold to save and exit.
Note

See the battery icon for the battery status. means the battery is
fully charged, means that the battery is low, and means the
battery charging is abnormal.

When the low power note shows, charge the battery.

The auto power off takes effect only when the device enters the
standby mode and the device isn’t connected with HIKMICRO Sight app
at the same time.

The auto power off countdown will start again when the device reenters
standby mode, or the device is restarted.
2.6 Auto Screen Off
Auto screen off function darkens the screen to save energy and increase
battery time.
Steps
1. Enable auto screen off.
1) Press to show the menu.

Hikmicro HABROK Series Specifications

General

Frame Rate	50 Hz
Pixel Interval	12 μm
Aperture	F1.0
Laser Rangefinder	Yes
Laser Rangefinder Max. Measuring Range	1000 m
Wavelength	905 nm
Protection Level	IP67
Battery Type	Li-ion
Operating Time	6h
Storage Temperature	-40 °C to 70 °C (-40 °F to 158 °F)