Hikmicro HM-TD3117T-1/Q User Manual

External Opcs/Window Correcon
Set the temperature of the external window or opcal material (e.g.: germanium window) to
correct the measured temperature.
Version
View the version of current algorithm.
Calibraon File Version
View the version of calibraon le.
Alarm Interval
Set the me interval of alarms.
Display Rule Info. on Alarm Picture
Select the rule informaon to be added on the alarm capture.
4.
Click Save.
3.3.2 Set Normal Mode
This funcon is used to measure the temperature of the whole scene and alarm.
Steps
1.
Go to Conguraon → Temperature Measurement → Basic Sengs , and check Enable
Temperature Measurement.
2.
Refer to
Set Thermometry Parameters to set the parameters.
3.
Go to Conguraon → Temperature Measurement → Advanced Sengs , and select Normal.
4.
Congure the parameters of normal mode.
Emissivity
Set the emissivity of your target. The emissivity of each object is
dierent.
Distance
The distance between the target and the device.
Pre-Alarm Threshold
When the temperature of target exceeds the pre-alarm threshold, and this status keeps more
than Filtering Time, it triggers pre-alarm.
Alarm Threshold
When the temperature of target exceeds the alarm threshold, and this status keeps more
than Filtering Time, it triggers alarm.
Pre-Alarm Output and Alarm Output
Check Pre-Alarm Output and Alarm Output to link the pre-alarm or alarm with the
connected alarm device.
Temperature Sudden Change Alarm
Thermographic Cube Camera User Manual
10

Hikmicro HM-TD3117T-1/Q Specifications

General

Brand	Hikmicro
Model	HM-TD3117T-1/Q
Category	Thermographic Cameras
Language	English