Hikmicro HM-TD3117T-1/Q - Access to Device Via Domain Name; Set HTTP Listening

9.4 Access to Device via Domain Name
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can
be mapped to a domain name resoluon server to realize the network access via domain name.
Before You Start
Registraon on the DDNS server is required before conguring the DDNS sengs of the device.
Steps
1.
Refer to
TCP/IP to set DNS parameters.
2.
Go to the DDNS sengs page: Conguraon → Network → Basic Sengs → DDNS .
3.
Check Enable DDNS and select DDNS type.
DynDNS
Dynamic DNS server is used for domain name
resoluon.
NO-IP
NO-IP server is used for domain name resoluon.
4.
Input the domain name informaon, and click Save.
5.
Check the device ports and complete port mapping. Refer to Port to check the device port , and
refer to
Port Mapping for port mapping sengs.
6.
Access the device.
By Browsers
Enter the domain name in the browser address bar to access the device.
By Client Soware Add domain name to the client soware. Refer to the client manual for
specic adding methods.
9.5 Set HTTP Listening
The device can send alarms to desnaon IP or host name through HTTP or HTTPS protocol. The
desnaon IP or host name should support the HTTP data transmission.
Steps
1.
Go to Conguraon → Network → Advanced Sengs → HTTP Listening .
2.
Input
Desnaon IP or Host Name, URL, and Port.
3.
Select Protocol.
Note
HTTP and HTTPS are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communicaon.
4.
Click Test.
5.
Click Save.
Thermographic Cube Camera User Manual
33