HikRobot CameraLink - Indicator Description

CameraLink Line Scan Camera·User Manual
4
No.
Signal
I/O Signal Source
Description
11
IO_OUT1_P
Line 4+
Differential output 1+
12
IO_OUT1_N
Line 4-
Differential output 1-
You should refer to the table above and the label attached to the power and I/O cable to
wire the device.
2.2 Indicator Description
The indicator has different status, and please refer to the following table for the details.
Table 2-2 Indicator Status Description
No.
Indicator Status
Description
1
Very slow flashing red
The data transmission exception occurs.
2
Solid blue
After starting up, the camera shows this status. No
data is transmitting.
3
Rapid flashing blue
The camera is acquiring images in internal trigger
mode.
4
Slow flashing blue
The camera is acquiring images in external trigger
mode.
5
Flashing blue and red in
alternative
The camera firmware is updating.
6
Flashing blue and red in
simultaneous
The camera exception occurs.
When the indicator is flashing slowly, its unlit interval is about 1 s.