CameraLink Line Scan Camera·User Manual
60
Figure 10-7 Load User Set
Loading parameters is available when connecting with camera, but without live view.
Set User Default
You can also set default parameter by selecting parameter from drop-down list of User Set Default,
as shown below.
Figure 10-8 Set User Default
Save the custom parameters setting and select it as the default one, otherwise the camera
adopts the default set every time after it being rebooted.
0 stands for the default factory set, 1 stands for the user set 1, 2 stands for the user set 2, and
3 stands for the user set 3.
10.5 Update Firmware
The camera supports updating firmware by using CameraLink cable or USB data cable.
Before updating, make sure power cable and others are properly connected.
You should stop the live view and disconnect the camera with MVS client software before
updating the firmware.
To Next Page
Loading...
