HikRobot CameraLink - Gamma and Color Transformation; Gamma Correction Settings; Color Transformation Control

CameraLink Line Scan Camera·User Manual
41
8.2 I/O Wiring
Here we take 4K camera as an example for I/O wiring, and these wirings are applicable to 8K
camera too.
8.2.1 Differential Singal Source Outputs Differential Signal
The camera can input differential signal via Line 0 or Line 3. 5 V differential signal source can be
selected to output differential signal. The specific wirings are shown below.
OUT A
Input 0 Positive(line0)or Input 1 Positive (Line3)
OUT Ã
Differential
Signal
Source
Camera Power
Signal Source Power
PWR
VCC
Camera Power Ground
Camera GND
Input 0 Negative (line0)or Input 1 Negative (Line3)
Signal Source GND
Figure 8-7 5 V Differential Signal Source Outputs Differential Signal
8.2.2 Differential Signal Source as Single-ended Signal
The specific wirings of 5 V and 12 V differential signal sources outputting single-ended signal are
shown below.
OUT A
Input 0 Positive (Line0) or Input 1 Positive (Line3)
OUT Ã
Differential
Signal
Source
Camera Power
Signal Source Power
PWR
VCC
Camera Power Ground
Camera GND
Input 0 Negative (Line0) or Input 1 Negative (Line3)
Signal Source GND
Signal Ground
Hang
Figure 8-8 5 V and 12 V Differential Signal Sources Output Single-ended Signal
8.2.3 Single-ended Signal Source Outputs Single-ended Signal
The specific wirings of 5 V and 12 V single-ended signal sources outputting single-ended signal are
shown below.