CameraLink Line Scan Camera·User Manual
29
6.3.5 Set Frame Grabber Trigger Control
When selecting CC1/CC2/CC3/CC4 as Trigger Source, the camera is in frame grabber trigger status.
Frame grabber triggers camera to acquire images by sending signal via CameraLink cable.
Figure 6-24 Set Frame Grabber Trigger
6.4 Trigger Related Parameters
Under external trigger mode, you can set frame burst, trigger delay, trigger activation, shaft
encoder counter, and trigger debouncer. Different trigger modes can set various trigger parameters,
and their relation is shown below.
Table 6-3 Trigger Mode and Trigger Parameter
To Next Page
Loading...
