EURO 280 Installation Manual
Page: 6
1.3 EURO 280 Input Mapping Table:
DEVICES Address Input Numbers
EURO 280 PCB PCB 1-8
EURO-ZEM8 / EURO-ZEM8+ / EURO-ZEM8+PSU / EURO-ZEM32-WE
0 9-16
1 17-24
2 25-32
3 33-40
4 41-48
5 49-56
6 57-64
7 65-72
8 73-80
9 81-88
10 89-96
11 97-104
EURO-ZEM8 / EURO-ZEM8+ / EURO-ZEM8+PSU
12 105-112
13 113-120
14 121-128
15 129-136
16 137-144
17
145-152
18
153-160
19
161-168
20
169-176
21
177-184
22
185-192
23
193-200
24
201-208
25
209-216
26
217-224
27
225-232
28
233-240
29
241-248
EURO-LCDPZ 0
249-250
EURO-LCDPZ / EURO-PROXI*
1
251-252
2 253-254
3 255-256
4 257-258
5 259-260
6 261-262
7 263-264
8 265-266
9 267-268
10 269-270
11 271-272
12 273-274
13 275-276
14 277-278
15 279-280
Total 280
NOTE 1: 3 x EURO-ZEM32-WE can be connected to the EURO 280. This expander allows 32 inputs which are
separated into 4 addresses (each address enables 8 wireless inputs). It is possible to mix the wired and wireless
remote expanders. When installing a EURO-ZEM32-WE, the first wireless expander will learn the 32 wireless
keyfobs and 2 wireless sounders. If this expander is disconnected, the keyfobs and sounders will need to be
learnt on another expander again.
*NOTE 2: If the EURO-PROXI (Internal Tag Reader) is programmed as a 'Set/Unset' device, 2 inputs can be
programmed. If the EURO-PROXI is programmed as 'Entry Control' or 'Access Control' only 1 input can be
programmed.
To Next Page
Loading...
