Control Panel User Manual
75
When you set the start and end time as non-zero, the start time
must be 5min greater than the end time of the previous time
bucket.
When you set the start and end time as non-zero, if the time bucket
is overlapped with the latter ones, or the difference between them
is less than 5min, all the settings of the latter ones will be cleared.
{12} Three types of Arming/Disarming.
Real-time
Arming/Dis
arming
{13} End the command.
Enabling Trigger Schedule
To enable the trigger schedule, please refer to the command below.
{1} Enabling Trigger Schedule Command Address: 697.
{2} It indicates to enable/disable the trigger schedule.
{3} End the command.
Trigger Schedule Trigger Parameter Configuration
To configure the trigger parameters of the trigger schedule, please refer to the
command below.
To Next Page
Loading...
