User Manual of Network Fisheye Camera
102
Figure 6-50 Video Tampering Detection Settings
3. Draw the detection area as in the normal configuration mode.
4. Move the slider to set the sensitivity.
5. Click Arming Schedule to set arming schedule as that in Task 2 Set the Arming
Schedule for Motion Detection in Section 6.6.1.
6. Click Linkage Method to set linkage method as that in Task 3 Set the Linkage
Method for Motion Detection in Section 6.6.1.
7. Click Save to save the settings.
6.6.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input Settings interface:
Configuration > Events > Basic Event > Alarm Input
To Next Page
Loading...
