User Manual of Network Fisheye Camera
17
Refer to the Figure 2-2 to set network camera over the LAN via a switch or a
router.
Connecting Directly
Connecting via a Switch or a Router
Creating a Password
You are required to activate the camera first by setting a strong password for it before
you can use the camera.
Creating a Password via Web Browser, Creating a Password via SADP, and Creating a
Password via Client Software are all supported.
Creating a Password via Web Browser
Steps:
1. Power on the camera, and connect the camera to the network.
2. Input the IP address into the address bar of the web browser, and click Enter to
enter the activation interface.
Notes:
The default IP address of the camera is 192.168.1.64.
For the camera enables the DHCP by default, the IP address is allocated
automatically. And you need to activate the camera via SADP software. Please refer to
the following chapter for Activation via SADP.
To Next Page
Loading...
