User Manual of Network Fisheye Camera
87
3) Check the Enable checkbox to enable ROI function for the chosen region.
4) Select the ROI level.
5) Enter a region name for the chosen region.
6) Click Save the save the settings of ROI settings for chosen fixed region.
7) Repeat steps 1) to 6) to setup other fixed regions if supported.
4. Click Save to save the settings.
Note: ROI level means the image quality enhancing level. The larger the value is, the
better the image quality would be.
Display Info.on Stream
Steps:
1. Enter the Display Info.on Stream Settings interface:
Configuration > Video/Audio > Display Info.on Stream
Figure 6-41 Display Info.on Stream Settings
2. Check the checkbox of Enable Dual-VCA, and the information of the objects (e.g.,
human, vehicle, etc.) will be marked in the video stream. And then you can set
rules on the connected rear-end device to detect the events including line crossing,
intrusion, etc.
6.5 Configuring Image Parameters
6.5.1 Configuring Display Settings
Purpose:
You can set the image quality of the camera, including brightness, contrast, saturation,
To Next Page
Loading...
