User Manual of Network Fisheye Camera
43
The preset name turns from black to grey.
Setting/Calling/Deleting a Patrol
Purpose:
A patrol is a scanning track specified by a group of defined presets, with the duration
time at each preset separately programmable.
Before you start:
At least 2 presets are required to set a patrol.
Setting a Patrol
Steps:
1. Click the icon to enter the patrol configuration interface.
Figure 5-6 Patrol Configuration (1)
2. Select a path No. from the drop-down list, and click the icon to configure
patrol path.
3. Click to add a preset into the path, and click to delete a preset.
4. Set the preset number, speed and lingering time at each preset. You can adjust the
order of presets by using and .
Figure 5-7 Patrol Configuration (2)
5. Click OK to save patrol path.
Note: Up to 32 patrol paths can be set, and each path supporting 16 key points at
To Next Page
Loading...
