User Manual of Network Fisheye Camera
48
Time and DST Settings
Purpose:
You can follow the instructions in this section to configure the time synchronization
and DST settings.
Time Settings
Steps:
1. Enter the Time Settings interface:
Configuration > System > System Settings > Time Settings
Figure 6-3 Time Settings
2. Select the Time Zone of your location from the drop-down list.
Synchronizing Time by NTP Server.
(1) Check the NTP item to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions with NTP
server.
To Next Page
Loading...
