User Manual of Network Fisheye Camera
110
Storage Settings
7.1 Configuring Recording Schedule
Purpose:
There are two kinds of recording for the cameras: manual recording and scheduled
recording. For the manual recording, refer to Section 5.3 Recording and Capturing
Pictures Manually. In this section, you can follow the instructions to configure the
scheduled recording. By default, the record files of scheduled recording are stored in
the memory card (if supported) or in the network disk.
Steps:
1. Enter the Record Schedule Settings interface:
Configuration > Storage > Schedule Settings > Record Schedule
Figure 7-1 Recording Schedule Interface
2. Check the checkbox of Enable to enable scheduled recording.
3. Click Advanced to set the camera record parameters, including overwrite,
pre-record, post-record and stream type.
To Next Page
Loading...
