User Manual of Network Fisheye Camera
118
Steps:
1. Enter Memory Card Detection configuration interface:
Configuration > Storage > Storage Management > Memory Card Detection
Memory Card Detection
2. View the memory card status on Status Detection tab.
Remaining Lifespan: It shows the percentage of the remaining lifespan. The
lifespan of a memory card may be influenced by factors such as its capacity and
the bitrate. You need to change the memory card if the remaining lifespan is not
enough.
Health Status: It shows the condition of your memory card. There are thrree
status descriptions, good, bad, and damaged. You will receive a notification if the
health status is anything other than good when the Arming Schedule and
Linkage Method are set.
Note: It is recommended that you change the memory card when the health status
is not “good”.
3. Click R/W Lock tab to add a lock to the memory card.
With the R/W lock added, the memory card can only be read and write when it is
unlocked.
To Next Page
Loading...
