HIKVISION DS-2TD2637T-7/P User Manual

Set Expert Mode
Select the temperature measurement rules from Point, Line, or Area and congure parameters,
the device alarms if the alarm rules are met.
Steps
1.
Go to
Conguraon → Temperature Measurement & Fire Prevenon → Basic Sengs , check
Enable Temperature Measurement.
2.
Refer to
Set Thermography Parameters to set the parameters.
3.
Go to Conguraon → Temperature Measurement & Fire Prevenon → Advanced Sengs ,
select Expert.
4.
Select and enable the temperature measurement rules. Please refer to
Set Thermography Rule
for seng the rule.
5.
Oponal: Click Area's Temperature Comparison to set the alarm rules and the temperature.
6.
Click Save.
The maximum temperature and thermography rules will be displayed on the live view.
Note
Go to Image → VCA Rules Display to adjust the font size and the temperature color of normal,
alarm and pre-alarm.
7.
Enable the scan funcon of device, such as linear scan to monitor the scene.
Set Thermography Rule
Steps
1.
Customize the rule name.
2.
Select the rule type to Point, Line, or Area. Then draw a point, line, or area on the interface
where the
posion to be measured.
Point
Please refer to Point Thermography for detailed conguraon.
Line Please refer to Line Thermography for detailed conguraon.
Area Please refer to Area Thermography for detailed conguraon.
3.
Congure the temperature measurement parameters.
Emissivity
Set the emissivity of the target. The emissivity of the surface of a material is its eecveness
in eming energy as thermal radiaon. Dierent objects have dierent emissivity. Refer to
Common Material Emissivity Reference to search for the target emissivity.
Distance
The distance between the target and the device.
Reecve Temperature
Thermal Opcal Bi-spectrum Network Camera User Manual
50

HIKVISION DS-2TD2637T-7/P Specifications

General

Brand	HIKVISION
Model	DS-2TD2637T-7/P
Category	Security Camera
Language	English