Wireless Router • User Guide
98
Remote web management parameter description
It is used to enable or disable the remote management function of the
router.
It specifies the IP address of the host which can access the web UI of the
router remotely.
All: It indicates that hosts with any IP address from the internet can
access the web UI of the router. It is not recommended for security.
Specific: Only the host with the specified IP address can access the
web UI of the router remotely. If the host is under a LAN, ensure that
the IP address is the IP address of the gateway of the host (a public IP
address).
It specifies the port number of the router which is opened for remote
management. Change it as required.
The port number from 1 to 1024 has been occupied by familiar
services. It is strongly recommended to enter a port number from
1025 to 65535 to prevent conflict.
Remote management can be achieved by visiting "http://the WAN IP
address of the router:port number". If the DDNS host function is
enabled, the web UI can also be accessed through "http://the
domain name of the router's WAN port:port number".
It specifies the port number of the router which is opened for remote management. Change it as
required.
Scenario: You encounter a problem in configuring the router, and the router can access the
internet.
Goal: Ask technical support to help you configure the router remotely.
Solution: You can configure the remote management function to reach the goal.
Assume that:
- The IP address of the device that remotely accesses the web UI: 210.76.200.101
- The WAN port IP address of the router: X.X.X.X
To Next Page
Loading...
Need help?
General
