Wireless Router • User Guide
85
Procedures:
Launch a web browser on a device connected to the router and visit
http://hikvisionwifi.local to log in to the web UI of the router.
Set the server host as the DMZ host.
1) Navigate to Advanced > DMZ Host.
2) Set DMZ Host to Enable.
3) Enter the IP address of the host, which is 192.168.0.125 in this example.
4) Click Save at the bottom of the page.
Enter the IP address of the host
Assign a fixed IP address to the host where the server locates.
1) Navigate to Advanced > IP-MAC Binding.
2) Enter the IP Address for the FTP server host, which is 192.168.0.125 in this example.
3) Enter the MAC Address of the host of the FTP server, which is 00:00:00:00:00:01 in this
example.
4) Click .
IP-MAC binding
5) Click Save at the bottom of the page.
When the configurations are completed, users from the internet can access the DMZ host by
visiting “Intranet service application layer protocol name://WAN IP address of the router”. If the
intranet service port number is not the default number, the visiting address should be: “Intranet
service application layer protocol name://WAN IP address of the router:intranet service port
number”.
In this example, the address is "ftp://X.X.X.X". You can find the WAN IP address of the router in
View system information.
To Next Page
Loading...
Need help?
General
