HIKVISION DS-7100NI-Q1/P Series - Page 75

Note
This funcon is only available for certain models.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes of
the
detecon region.
6. Set the arming schedule. Refer to
Congure Arming Schedule for details.
7. Set the linkage acons. Refer to Congure Alarm Linkage Acon for details.
8. Click Apply.
Region Entrance Detecon
Region entrance detecon funcon detects people, vehicles or other objects which enter a pre-
dened
virtual region from the outside place, and some certain acons can be taken when the
alarm is triggered.
Steps
1. Go to
Conguraon → Event → Smart Event → Region Entrance .
2. Set Camera.
3. Turn on Enable.
4. Oponal: Check Save VCA Picture to save the captured pictures of VCA detecon.
5. Set the detecon rules and detecon areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Adjust
Sensivity. Sensivity: Range [0-100]. The higher the value is, the more easily the
detecon alarm can be triggered.
3)
Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle.
Note
This funcon is only available for certain models.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes of
the
detecon region.
6. Set the arming schedule. Refer to Congure Arming Schedule for details.
7. Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
8. Click Apply.
Region
Exing Detecon
Region exing detecon funcon detects people, vehicles or other objects which exit from a pre-
dened virtual region, and some certain acons can be taken when the alarm is triggered.
Steps
1. Go to Conguraon → Event → Smart Event → Region Exing .
2. Set Camera.
3. Turn on Enable.
Network Video Recorder User Manual
61