User Manual of DS-7200/7300/8100 Series DVR
174
Figure 9. 33 Installed Certificate Property
4. Check the checkbox to enable the HTTPS function.
The HTTPS Port should be set to the range of 1-65535.
9.2.8 Configuring Email
Purpose:
The system can be configured to send an Email notification to all designated users if an alarm event is
detected, a motion detection event is detected, etc.
Before configuring the Email settings, the device must be connected to a local area network (LAN) that
maintains an SMTP mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which you want to send notification.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the Network
Settings menu.
Figure 9. 34 Network Settings Interface
3. Click the Apply button to save the settings.
4. Select the Email tab to enter the Email Settings interface.
To Next Page
Loading...
Need help?
General