User Manual of DS-7200/7300/8100 Series DVR
191
10.4 Configuring Quota Mode
Purpose
Each camera can be configured with allocated quota for the storage of recorded files.
Steps
1. Enter the Storage Mode interface.
Menu > HDD > Advanced
2. Set the Mode to Quota.
The device must be rebooted to enable the changes to take effect.
Figure 10. 14 Storage Mode Settings Interface
3. Enter the storage capacity in the text field of Max. Record Capacity (GB).
Figure 10. 15 Configure Record Quota
4. You can copy the quota settings of the current camera to other cameras if required. Click the Copy button
to enter the Copy Camera menu, as shown below.
Figure 10. 16 Copy Settings to Other Camera(s)
5. Select the camera (s) to be configured with the same quota settings. You can also click the checkbox of
Analog to select all cameras.
6. Click the OK button to finish the Copy settings and back to the Storage Mode interface.
7. Click the Apply button to apply the settings.
If the quota capacity is set to 0, then all cameras will use the total capacity of HDD for recording.
To Next Page
Loading...
Need help?
General