User Manual of DS-7200/7300/8100 Series DVR
96
5.6 Configuring Manual Record
Purpose:
Follow the steps to set parameters for the manual record. When using manual record, you need to manually
cancel the record. The manual recording is prior to the scheduled recording.
Steps:
1. Enter the Manual settings interface.
Menu> Manual
Figure 5. 28 Manual Record
The IP Camera is supported by HDVR series only.
2. Enable recording for camera (s).
Click the status button beside each camera number to change to , or you can enable
recording for all cameras by clicking the status bar before Analog to change it to .
3. Set recording mode to manual.
By default, the camera is enabled with recording by schedule ( ). Click the status bar to
change it to and click again to enable the recording to manual ( ).
: recording by schedule.
: recording by manual operation.
After rebooting, all the manual records enabled are canceled.
4. Start all-day continuous recording or all-day motion detection recording of all channels.
1) Click for Continuous or Motion Detection recording.
Figure 5. 29 Start Normal or Motion Detection Recording
2) Click Yes to enable all-day continuous or motion detection recording of all channels.
To Next Page
Loading...
Need help?
General