User Manual of DS-9600/8600/7700/7600 Series NVR
154
Figure 9. 10 Register an Account
3) In the Device Management interface, click to register the device.
Figure 9. 11 Register the Device
Note: The device name can only contain the lower-case English letter, numeric and
‘-’; and it must start with the lower-case English letter and cannot end with ‘-’.
5. Click to save and exit the interface.
9.2.3 Configuring NTP Server
Purpose:
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of
system date/time.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the NTP tab to enter the NTP Settings interface, as shown in Figure 9. 12.
Figure 9. 12 NTP Settings Interface
3. Check the Enable NTP checkbox to enable this feature.
4. Configure the following NTP settings:
To Next Page
Loading...
