User Manual of DS-9600/8600/7700/7600 Series NVR
192
11.3 Managing eSATA
Note: This function is not supported with DS-7600NI-SE(/N) series NVR.
Purpose:
When there is an external eSATA device connected to NVR, you can configure eSATA for the use
of Record/Capture or Export, and you can manage the eSATA in the NVR.
Steps:
1. Enter the Advanced Record Settings interface.
Menu >Record>Advanced
2. Select the eSATA type to Export or Record/Capture from the dropdown list of eSATA.
Export: use the eSATA for backup. Refer to Backup using eSATA HDDs in Chapter
Backing up by Normal Video Search for operating instructions.
Record/Capture: use the eSATA for record/capture. Refer to the following steps for
operating instructions.
Figure 11. 10 Set eSATA Mode
3. When the eSATA type is selected to Record/Capture, enter the HDD Information interface.
Menu > HDD>General
4. Edit the property of the selected eSATA, or initialize it is required.
Note: Two storage modes can be configured for the eSATA when it is used for
Record/Capture. Please refer to Chapter Managing HDD Group and Chapter Configuring
Quota Mode for details.
Figure 11. 11 Initialize Added NetHDD
To Next Page
Loading...
