Network Video Recorder User Manual
106
It will send an exception or alarm signal to the remote alarm host when an event occurs. The
alarm host refers to the PC installed with Remote Client.
The alarm signal will be transmitted automatically at
detection mode when remote alarm host is configured.
Please refer to Chapter 14.8 Configuring NAT
Purpose:
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
UPnP
TM
Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Go to Menu > Configuration > Network > NAT.
UPnP™ Settings Interface
Check Enable UPnP.
Select Mapping Type as Manual or Auto.
OPTION 1: Auto
To Next Page
Loading...
Need help?
General
