HIKVISION DS-K1T804AMF - Page 33

No. manually, you should enable Press Key to Input Card
No.. For details, see Congure Parameters for Access
Control Device.
FP (Fingerprint)
On the Fingerprint page, select a target nger and record
according to the voice prompt.
Note
•
The same ngerprint cannot be repeatedly added.
•
Up to 10 ngerprints can be added to one user.
•
You can also scan the ngerprints via the external
ngerprint recorder and apply the ngerprints to the
device by the client soware.
•
For detailed informaon about scanning the ngerprint,
see Tips for Scanning Fingerprint.
Dept. (Department)
Select a department in the list and edit the department.
Note
For detailed informaon about eding the department, see .
Plan (Template)
Move the cursor and select Set and select a template from
the list.
Note
For details about eding template, see Set Schedule
Template.
Auth.
Select an authencaon mode when verifying user's
permission.
Note
•
If you select the authencaon mode as Controller, you
should set the authencaon mode in Set System
Parameters. The system will authencate user's identy
according to the congured authencaon mode. By
default, the
authencaon mode is Controller. This mode
is applicable to edit users' authencaon modes in batch.
•
If an user needs to use a special authencaon mode,
which is dierent from the authencaon mode
congured in Set System Parameters, he can use card/
ngerprint, card, etc. The system will authencate the
user's
identy according to the congured authencaon
mode rst. This mode is applicable to edit single user's
authencaon mode, which has special permissions.
Role
Select the user's role as administrator or normal user.
•
Admin: The admin has all permissions to operate the device.
•
User: The normal user can check
aendance on the inial
page.
18