HIKVISION DS-K1T804AMF - Configure Other Parameters

Figure 8-3 Select Card Reader Authencaon Mode
Note
PIN refers to the PIN code set to open the door. Refer to
Congure Access Control Informaon.
2) Check the modes in the Available Mode list and they will be
added to the selected modes list.
3) Click OK.
Aer selecng the modes, the selected modes will display as
icons with dierent color.
4.
Click the icon to select a card reader
authencaon mode, and
drag the cursor to draw a color bar on the schedule, which
means in that period of me, the card reader authencaon is
valid.
5.
Repeat the above step to set other
me periods.
Figure 8-4 Set Authencaon Modes for Card Readers
6.
Oponal: Select a congured day and click Copy to Week to
copy the same
sengs to the whole week.
7.
Oponal: Click Copy to to copy the sengs to other card
readers.
8.
Click Save.
8.5.5
Congure Other Parameters
Aer adding the access control device, you can set its parameters
such as network parameters, capture parameters, RS-485
parameters, Wiegand parameters, etc.
Set Network Parameters
66