HIKVISION DS-K1T804AMF - 7.7 Attendance Status; 7.7.1 Set Auto Attendance

marked as check in. And the valid person's authencaon aer
17:00 on Monday will be marked as check out.
5.
Press ESC and save the sengs.
Result
Enter the inial page, the current aendance mode will be
displayed on the page. When you authencate on the inial page,
the authencaon will be marked as the congured aendance
status according to the congured schedule.
7.7.2 Set Manual Aendance
Set the aendance mode as manual, and you can select a status
manually when you take
aendance.
Before You Start
Add at least one person, and set the person's authencaon
mode. For details, see Person Management.
Steps
1.
Move the cursor and select System →
A. Status to enter the
Aendance Status page.
2.
Move the cursor and select Aendance Mode and set the
aendance mode as Manual.
Figure 7-16 Manual Mode
Note
Make sure the aendance status is enabled. By default, it is
enabled.
3.
Press ESC and save the aendance mode.
4.
Move the cursor and select Shortcut Key and
dene the
shortcut key's aendance status.
5.
Press ESC and save the
sengs.
Result
Press a key on the keypad to select an aendance status and
authencate. The authencaon will be marked as the congured
aendance
status according to the dened shortcut key.
Or when you authencate on the inial page, you will enter the
Select Status page. Select a status to take aendance.
Note
If you do not select a status for about 20 s, the authencaon will
be failed and it will not be marked as a valid aendance.
7.7.3 Set Manual and Auto Aendance
Set the aendance mode as manual and auto and the system will
auto change the
aendance status according to the congured
parameters. At the same me you can manually change the
aendance status before the authencaon.
25