HIKVISION DS-K1T804AMF - System Upgrade; Restore Settings

When the funcon is enabled, the system will remind you to
delete records. The system will delete the rst 3000
aendance records when the memory reaches the
congured threshold, in order to save the new aendance
records. By default, the funcon is enabled. For details, see
Aendance Record Deleng Rule.
Language
Change the system language. Aer you change the system
language, the device will reboot
automacally.
4.
Press ESC and select Yes to save the
sengs and exit the page.
7.10.4 System Upgrade
You can upgrade the system online or locally. The system reads
the upgrading
le in the plugged USB ash drive or gain the
upgrading package from the plaorm to upgrade the device.
Steps
1.
Move the cursor and select System → Upgrade .
2.
Upgrade the system.
-
Local Upgrade: Plug the USB ash drive to the USB interface.
Press OK. The system will read the digicap.dav le and
upgrading automacally. Aer the upgrading is completed,
the device will reboot
automacally.
Note
•
The upgrading le should be in the root directory.
•
The upgrading le name in the USB ash drive should be
digicap.dav.
•
Do not power
o during the device upgrading.
•
Aer the upgrading is completed, remove the USB ash
drive.
-
Online upgrade: The system will gain the upgrade package
from the
plaorm to upgrade.
7.10.5 Restore
Sengs
Restore system parameters to factory sengs or default sengs.
Steps
1.
Move the cursor and select System → Reset .
2.
Press OK to enter the Reset page.
Figure 7-33 Reset Page
3.
Select Factory Sengs or Default Sengs.
Factory
Sengs
All parameters of the device will restore to the factory
parameters.
Default Sengs
37