HIKVISION DS-KD8003 Series - Page 52

Figure 4-32 Placement of Lines
6.
Connect the cables.
1) Connect the lines and
module-connecng line 1 to the corresponding interfaces of the main
unit, then place the main unit into the upper grid.
2) Connect the other end of the
module-connecng line 1 to the input interface of the sub
module. Connect two sub modules via module-connecng line 2.
3) Organize the cables with cable e in the package. The suggested cable connecon picture as
shown below.
DS-KD8003 Series Module Door Staon User Manual
44