HIKVISION DS-KH6350-WTE1 - Device Pairing

Figure 3-5 Select Device Pairing Mode
-
Quick pairing: The indoor staon and the door staon will be paired automacally.
1. Set the indoor staon's room No. and tap Next.
2. Select the door staon that you need to connect. The door staon with the same LAN as
the indoor
staon will be displayed in the list.
Note
If select mulple door staons, uncheck the main door staon, and tap Main to change a
main door staon, and the others are sub door staons.
3. Select the indoor extension that need to connect. The indoor extension with the same LAN
as the indoor
staon will be displayed in the list.
-
Advanced Pairing: The indoor
staon and the door staon should be paired manually.
1. Set the indoor
staon's oor No., room No., build No., unit No.
2. Set the indoor staon's wired network parameters, you can choose to enable DHCP or
manually set the IP address, subnet mask, and default gateway.
3. Select the door
staon that you need to connect. The door staon with the same LAN as
the indoor staon will be displayed in the list.
Note
If select mulple door staons, uncheck the main door staon, and tap Main to change a
main door staon, and the others are sub door staons.
Network Indoor Staon Conguraon Guide
6