HIKVISION DS-KH6350-WTE1 User Manual

Figure 4-11 Zone Alarm
2.
Select Area No.
3.
Select Zone Type from the drop-down list.
4.
Select Alarm Type from the drop-down list.
5.
Set the NO/NC status.
6.
Set Entering Delay and
Exing Delay.
7.
Click Save to enable zone sengs.
Note
●
7 zone types are supported: Emergency Switch, Door Magnec Switch, Smoke Detector, Acve
IR Detector, Passive IR Detector, Combusble Gas Detector, and DoorBell Switch.
●
3 types of alarm mode are supported: Instant Alarm, 24H Alarm, and Delay Alarm.
●
When the zone type is set to be Instant Alarm, only under arming mode, the indoor
staon
will receive alarm message when the detector is triggered. Under disarming mode, it will not
receive alarm message when the detector is triggered.
Network Indoor Staon Conguraon Guide
53

HIKVISION DS-KH6350-WTE1 Specifications

General

Color	Yes
Connectivity technology	Wired & Wireless
Number of displays supported	1
Maximum number of cameras supported	-
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	128 GB
Flash memory	32 MB
Internal memory	128 MB
Alarm input channels	8
Operating system installed	Embedded LINUX
Package weight	683 g
Outdoor unit included	No
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	TFT
Product color	Black
Voice codecs	G.711a, G.711u
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, SIP, RTSP
Power consumption (typical)	8 W

Weight and Dimensions

Depth	21 mm
Width	175 mm
Height	113.5 mm
Weight	355 g