EasyManuals Logo

HIKVISION DS-KH6350-WTE1 User Manual

HIKVISION DS-KH6350-WTE1
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
When the zone type is set to be 24H Alarm, the indoor staon will receive alarm message
when the detector is triggered no maer it is under arming mode or disarming mode.
When the zone type is set to be Delay Alarm, only under arming mode, the indoor staon will
receive alarm message when the detector is triggered. Under disarming mode, it will not
receive alarm message when the detector is triggered.
Aer seng enter delay me, if OK is pressed within the enter delay me aer the alarm, the
alarm event will not be uploaded to the management center; if OK is not pressed within the
enter delay me aer the alarm, the alarm event will be uploaded to the management center.
The exit delay is the me between you enable the arming mode and the arming takes eect.
Network Camera Informaon
You can add, delete and edit cameras that can be added to the video intercom products, with two
ways of geng stream: direct or URL. By exporng and imporng the added device informaon,
you can edit added devices parameters in batch.
Add Camera
Steps
1.
Click IP Camera Informaon to enter IP camera informaon page.
Figure 4-12 IP Camera
Informaon
2.
Click Add to pop up the device adding dialog box.
3.
Enter corresponding informaon (device name, IP address, port No., user name, password, etc.),
and click OK.
Note
Indoor extension does not support this funcon.
Export and Import Added Device Informaon
Steps
1.
Click Export to export the added device informaon le.
2.
Edit parameters of added devices in batch in the exported le.
3.
Click Import to pop up imporng box, and open the edited added device informaon le.
Network Indoor Staon Conguraon Guide
54

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-KH6350-WTE1 and is the answer not in the manual?

HIKVISION DS-KH6350-WTE1 Specifications

General IconGeneral
ColorYes
Connectivity technologyWired & Wireless
Number of displays supported1
Maximum number of cameras supported-
Compatible memory cardsMicroSD (TransFlash)
Maximum memory card size128 GB
Flash memory32 MB
Internal memory128 MB
Alarm input channels8
Operating system installedEmbedded LINUX
Package weight683 g
Outdoor unit includedNo
Display diagonal7 \
Touchscreen typeCapacitive
Display resolution1024 x 600 pixels
Display technologyTFT
Product colorBlack
Voice codecsG.711a, G.711u
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates10, 100 Mbit/s
Ethernet interface typeFast Ethernet
Supported network protocolsTCP/IP, SIP, RTSP
Power consumption (typical)8 W
Weight and Dimensions IconWeight and Dimensions
Depth21 mm
Width175 mm
Height113.5 mm
Weight355 g

Related product manuals